FCSS - SD-WAN 7.6 Architect

Refer to the exhibit.

FortiManager SD-WAN monitor -

To check the status of an SD-WAN topology using the FortiManager SD-WAN monitor menus, you place your mouse next to branch1_fgt and receive the output shown in the exhibit.
Which conclusion can you draw from the output shown in the exhibit?

Refer to the exhibit, which shows the SD-WAN rule status and configuration.
SD-WAN rules status and configuration

Based on the exhibit, which change in the measured packet loss will make HUB1-VPN3 the new preferred member?

Refer to the exhibits.

Global System configuration -


Interface port2 configuration -


Routing Table on FortiGate -

The administrator increases the member priority on port2 to 20.
Upon configuration changes and the receipt of new packets, which two actions does FortiGate perform on existing sessions established over port2? (Choose two.)

You are configuring ADVPN 2.0 on an SD-WAN topology already configured for ADVPN.
What should you do to implement ADVPN 2.0 in this scenario?

As an IT manager, you want to delegate the installation and management of your SD-WAN deployment to a managed security service provider (MSSP).
Each site must maintain direct internet access and be secure. You expect significant traffic flow between the sites and want to delegate as much of the network administration and management as possible to the MSSP.
Which two MSSP deployment blueprints address your requirements? (Choose two.)